This is for a Multi Pack of grits containing one 6" x 4" sheet of each grit (6,000 / 8,000 and 12,000). Three sheets in total.
MICRO-MESH™ THE NON-ABRASIVE ABRASIVE
Micro-Mesh™ is what we like to call a non-abrasive abrasive. It is considered a cushioned abrasive in fact.
Conventional sandpaper is designed to be aggressive so that it will dig deeply. In its manufacture the crystals are electrically charged so that they will stand up. They are locked into a hard resin and when you apply the paper to a surface it will literally tear in and remove the substrate of the material you are sanding. The crystals cut in a negative raking motion, leaving inconsistent scratch patterns.
Micro-Mesh™ does the opposite. The backing is long lasting cloth to which an ultra-flexible cushioning layer is applied. This cushioning layer will determine how far forward you can push crystals before they will penetrate the cushioning layer. On top of this layer, we have a very resilient glue, not a hard resin, but a completely flexible glue that will hold the crystals while allowing it to move and rotate. The crystals can turn in any direction without coming loose. When you start to apply pressure to sand with Micro-Mesh™, the crystals will go into the cushioning layer while beginning to cut a bit. If you push harder, they will go further into the cushioning layer, which serves as a safety valve. It determines how much pressure you can exert in a doward direction. Instead of a deep scratch that sandpaper makes, Micro-Mesh™ produce a refined scratch that is close to a RMS of 1.0. The cushioning layer also allows the crystals to cut with a planing motion that leaves an extremely consistent scratch pattern and allows you to achieve extraordinary levels of gloss.
Where conventional abrasives will take surfaces down 2 or 3 thousandths (.002 or .003), Micro-Mesh™ will take it down one ten thousandth (.0001) or less.
ULTRA-FLEX MICRO-MESH™ REGULAR
Use these products for finishing plastics, acrylics, polycarbonates, bakelite, fiberglass, gelcoat, urethanes, celluloid,laquers, fiberglass, cast polymers, soft woods, cultured marble, coatings, composites, and more.
Abrasive colors of this product range from dark grey to light grey. This material is made to be used wet or dry, is made with a flexible cotton backing with polymer emulsion cushioning layer and large micron graded silicon carbide crystals suspended in an ultra flexible resin bond. *Grades 8000 and 12000 are made with aluminum oxide crystals.
This material is available in the following 3 grades, from 6000, 8000* and 12000*.